Immobilization of thiabendazole-specific monoclonal antibodies to silicon substrates via aqueous silanization

Monoclonal antibodies specific for thiabendazole were immobilized to silicon, silicon dioxide, stoichiometric silicon nitride, and silicon-rich silicon nitride surfaces. This work provides the foundation for the development of a homogeneous sensor system for rapid detection and quantification of thiabendazole residues in produce and animal tissue. Immobilization was performed via aqueous silanization of the substrate followed sequentially by treatment with glutaraldehyde and contact with antibody solution in the presence of detergent. Surfaces were challenged with thiabendazole-horseradish peroxidase conjugate in an ELISA format to estimate immobilized antibody load. A stable and reproducible surface loading of 2 x 10¹¹ antibodies/cm² was obtained only after surfaces received postimmobilization treatments to remove nonspecifically adsorbed antibody. No difference in surface loading was noted when using 30% hydrogen peroxide rather than nitric acid for silanol activation. Little difference was noted among the antibody loadings achieved on the various silicon substrates. Bound antigen-enzyme conjugate was eluted with 0.1N acetic acid and reproducible surface activity was measured for up to four consecutive antigen challenges. Immobilized antibody surfaces were stabilized with 2% sucrose, dehydrated at 37‡C and stored in vacuum or stored at 4‡C in phosphate buffered saline containing 0.01% sodium azide without significant loss of activity.     

尿素作为添加剂低温制备高活性的TiO2光催化剂

以钛酸丁酯为原料,尿素作为添加剂,在酸性水溶液中室温制备了稳定透明的TiO2水溶胶。经过300℃低温焙烧2 h,得到了由锐钛矿和金红石组成的TiO2混晶。用XRD、FT-IR对催化剂进行了表征。以甲基橙为降解对象研究了TiO2的光催化活性,实验结果显示所制备的TiO2具有比Degussa P25更高的催化活性,15m in后的降解率达到了78%(P25,58%)。考察了尿素添加量以及焙烧温度对TiO2催化性能的影响,当尿素与钛酸丁酯物质的量之比为3∶1,300℃下焙烧2 h为较适宜的催化剂制备条件。初步探讨了尿素作为添加剂在低温制备高活性TiO2过程中的作用。     

石英晶体微天平技术研究纳米TiO_2表面Cu(Ⅱ)吸附与光化学还原过程

环境中排放的重金属离子Cu!对水生和陆生生物有强的毒害性。饮用水中Cu!的浓度高于1.0mg·L-1时,将会导致人畜得血色沉着病和胃肠粘膜病[1]。Cu!无法进行生物降解,除去废水中Cu!的常见方法有离子交换、置换、化学沉淀等[2],然而这些方法需要消耗大量的化学试剂,成本高。近来,研     

二氧化碳与丙烯直接合成甲基丙烯酸用CuPMo／TiO2催化剂的研究

 用溶胶－凝胶法以磷钼酸（MPA）的铜盐溶液水解钛酸四丁酯制备了CuPMo／TiO2催化剂，并用ICP，XRD，TG－DTA，IR，TPD－MS和微反技术研究了催化剂的化学组成、热稳定性、化学吸附性质和催化性能．结果表明：杂多钼酸盐与TiO2表面通过O2－桥发生键联．在623K下，杂多阴离子仍保持其原有的Keggin结构；CO2在Lewis酸位Cu（Ⅱ）和Lewis碱位Cu－O－Mo桥氧的协同作用下形成卧式吸附态Cu（Ⅱ）←O－（CO）←（O－－Cu）；丙烯以分子吸附态在催化剂上吸附；在空速1500h－1，压力1MPa和温度563K的反应条件下，丙烯的转化率为4．2％，甲基丙烯酸的选择性为96％．     

蒙脱石修饰碳糊电极测定氨基酸的研究：Ⅱ.酪氨酸的测定

本文报道蒙脱石修饰碳糊电极测定酪氨酸，在０．００１ｍｏｌ／Ｌ ＫＣｌ－ＨＣｌ（ｐＨ＝２．０）溶液中开路富集，介质交换后微分脉冲阳极溶出伏安法测定，在０．５－２．５μｇ／ｍｌ范围内有线性，检测限为６３ｎｇ／ｍｌ。可避免其他氨基酸，微量元素和常量金属元素的干扰，直接用于氨基酸药物样品的分析，获得了满意的结果，还对酪氨酸在电极上的反应机理进行了探讨。     

Influence of the conditions of manufacture of nanomeric zirconium dioxide,stabilized with yttrium oxide,on its catalytic properties in the oxidation of CO

The morphological and catalytic properties of samples of nanomeric zirconium dioxide, stabilized with yttrium oxide, manufactured via the effect of a UHF field during the process of drying precipitated zirconium hydroxide and calcination at temperatures from 300 to 1000 °C, were studied. It was shown that the highest activity in the oxidation of CO occurred with 40 nm particles of zirconium dioxide prepared at 1000 °C. __________ Translated from Teoreticheskaya i éksperimental’naya Khimiya, Vol. 43, No. 2, pp. 96–101, March–April, 2007.     

二氧化碳氧化剂在烷烃催化转化反应中的应用研究进展

本文综述了近年来国内外有关利用二氧化碳作为氧化剂在烷烃催化转化反应中的研究状况。担载型的金属氧化物催化剂具有较好的催化活性。催化剂表面碱性位的存在可稳定活性中心并且有利于CO2的活化，CO2的作用是与烷烃脱氢产物H2和生成的表面积炭反应，从而提高反应活性及催化剂的稳定性。     

空气中苯系物的TiO2光催化降解研究进展

本文对近年来空气中挥发性苯系物的TiO2光催化降解机理、TiO2光催化降解苯系物的主要影响因素以及TiO2的失活与再生方法等的研究进展进行了较详尽的评述,并对今后的研究工作进行了展望。     

用碘酸钾滴定法标定二氧化硫标准溶液

用KIO3滴定法标定SO2标准溶液,RSD≈0.10%,标定结果与标准法结果无显著性差异,相对误差<±0.3%。